GW Instek GDM-8200A DMM-Viewer (PC Software) Guide - Manual (Page 12)

GDM-8200A Series Remote Viewer Guide
12
3. Press the Enter key to
confirm USB settings menu.
4. The USB ON or OFF
selection appears. Press the
Up or Down key to turn on.
Note: If using an RS232 connection, select the
USB OFF option.
5. Press the ENTER key to
confirm the USB (either on
or off) selection.
6. Press the EXT key to get out
of the configuration mode.
When the GDM82250A is turned off, the USB
configuration will be lost. Please see the User
Manual to keep the USB configuration as the
default configuration at startup. Firmware 2.10
and later is able to change the startup default
settings. For the latest firmware please see the
GWInstek website or contact your nearest
distributor.
3. Connect the
USB cable 1. Connect the USB cable to the
rear panel terminal (upper
port). CAL
KEY
2. Connect the other side of the USB cable to the PC.