Anritsu CMA 5000 - UTA - Manual (Page 11)

ISO 9001:2000 certified. ICMA5KUTASTM64-SPEC05-0806-A4. ©2008 Anritsu. All Rights Reserved. Page 11 of 14
Path Analysis
Signal Qualification • Power meter
• Frequency meter
Errors Analysis
• SONET/DSn
A1/A2, B1, B2, REI-L, B3, REI-P, V5, REI-V, FAW (FAS), SFAW, FPS, MAW, Parity P,
Parity CP, F-bit, M-bit, FEBE, CRC-6, PRBS, Word, ERR
• SDH/PDH
A1/A2, B1, B2, MS-REI, B3, LP-B3, HP-REI, V5, LP-REI, FAW (FAS), CRC-4, REI (E-bit or
REBE), PRBS, Word, ERR
Alarms Analysis
• SONET/DSn
LOS, LOF, SEF, TIM-S, AIS-L, RDI-L, AIS-P, LOP-P, TIM-P, PLM-P, UNEQ-P, RDI-P,
LOM-V, AIS-V, LOP-V, PLM-V, UNEQ-V, RDI-V, TIM-V, RFI-V, OOF, LSF, LOMF, RAI,
IDLE, LSS, LPS, AIS
• SDH/PDH
LOS, LOF, OOF, RS-TIM, MS-AIS, MS-RDI, AU-AIS, AU-LOP, HP-PLM, HP-TIM,
HP-UNEQ, HP-RDI, TU-LOM, TU-AIS, TU-LOP, LP-PLM, LP-UNEQ, LP-TIM, LP-RDI,
LP-RFI,
AIS, RDI, LOMF, LSS, LPS
Pointer Movement Analysis • Pointer value
• Number of positive and negative pointer movements
• Number of pointer movement with NDF
Quality Analysis • SONET
Transmission quality is calculated each second as per GR-253
• SDH/PDH
Transmission quality is calculated each second in accordance with recommendations G.826,
G.828, M.2100, M2101.1, M.2101, M.2110 for performance
Overhead Analysis • J0, J1 and J2 Path Trace messages (ASCII sequence)
• S1 (synchronization status)
• C2/V5 (signal label)
• Complete display of SOH/TOH and POH of the analyzed path channel
• Capture capacity: 64 consecutive frames
Event Analysis • Alarms and errors event analysis in temporal graphical display with 125 µs resolution
Round Trip Delay
• Measurement possible at each path level
• Resolution: 100 ns
• Range: 0 to 2 sec (depending on path level)
• Result: Maximum RTD, minimum RTD, Average RTD and errors/alarms detection
Automatic Protection Switching Measurement
• Number of switches
• Switch duration (with 125 µs resolution)
• K1/K2 capture and interpretation