Addonics Technologies ZBW-H63DEU - Manual (Page 2)

Configuring eSATA Connection:
The ZBW-H63DEU is plug and play in Windows. You should have configured the
eSATA host controller on your system before you connect the ZBW-H63DEU.
Once the eSATA host controller is configured, do the following steps below.
1. Connect the power adapter and eSATA cable to the enclosure.
Attached the other end of the eSATA cable to your eSATA host
controller.
2. Power ON the enclosure using the switch on the back panel. You
should see the Green Power LED on the front panel at the bottom right
light up.
3. To check if your system detects the Blu Ray drive, go to Device
Manager.
Note: It is important that you have configured correctly the driver of your
eSATA host controller before connecting the ZBW-H63DEU.
4. The Blu Ray drive will also show up in My Computer.
Configuring USB Connection:
The ZBW-H63DEU is plug and play in Windows using USB connection.
Using USB2.0 Connection:
1. Connect the power adapter to the back of the enclosure. Attach the
USB cable to the USB port on the enclosure and in your system.
2. Power ON the enclosure using the switch on the back panel. You
should see the Green Power LED on the front panel at the bottom right
light up.
3. To check if your system detects the Blu-ray/HD DVD-ROM drive, go to
Device Manager.
4. The Blu-ray/HD DVD-ROM drive will also show up in My Computer.
Blu-ray/HD
DVD-ROM
Drive
Blu-ray/HD
DVD-ROM
Drive
Driver of eSATA
host controller the
ZBW-H63DEU is
connected to.
Blu-ray/HD
DVD-ROM
Drive
Blu-ray/HD DVD-ROM
Drive
USB Driver