Martel Electronics SP5-1200-BL User Manual

Electrical specifications, Safety, Wire signal-powered meter

Advertising
background image

2-Wire Operation (excluding backlighting)

4 to 25V d.c. Full Scale Reading

18mm / 0.7" LCD Digit Height

Reverse Polarity Protection

No Calibration Required (pre-calibrated for use)

Splashproof

LED Backlighting (via separate supply)

Screw Terminal Connections

ELECTRICAL SPECIFICATIONS

Specification

Min.

Typ.

Max.

Unit

Accuracy (overall error)

0.2

V (±1 count)

Linearity

1

count

Valid displayed reading*

4.0

25.0

V d.c.

Resolution

100

mV d.c.

Supply voltage

Meter

3

50

V d.c.

Backlighting

5

V d.c.

Backlighting (@ 5V d.c.)

50

mA

+

Sample rate

3

samples/sec

Operating temperature range

0

50

°C

Supply current

Meter

(@ 9V d.c.)

1.5

mA

This low cost, compact indicator is ideally suited for low or high volume applications. SP 5-1200-BL is an easy to
mount LCD digital panel meter. The module features a 4 to 25V measurement range with 100mV resolution and
is powered from the signal it is measuring. Only valid readings are displayed; the module indicates "LO" at
voltages below 4V and "HI" at voltages above 25V. Screw terminals allow for quick and easy connection. The
module is panel mounted using the metal clip provided and a rubber seal is included, providing splashproof
protection for the unit when fitted to the meter during installation.

SP 5-1200-BL

2-Wire Signal-Powered Meter

* At voltages below 4.0V d.c., the LCD will display

and will ultimately go blank.

At Voltages in excess of 25.0V d.c., the LCD will display .
Do NOT exceed 50V d.c., as this may damage the meter.
The module includes reverse polarity protection up to 30V for up to 30 seconds.
Operation and accuracy at voltages above 25.0V or below 4.0V are not specified.

LO

HI

SAFETY

To comply with the Low Voltage Directive (LVD 93/68/EEC), input voltages to the module’s connections must not
exceed 60Vd.c. The user must ensure that the incorporation of the meter into the user’s equipment conforms to
the relevant sections of BS EN 61010 (Safety Requirements for Electrical Equipment for Measuring, Control and
Laboratory Use).

LASCAR ELECTRONICS LTD.
MODULE HOUSE
WHITEPARISH
WILTSHIRE

SP5 2SJ

UK
TEL: +44 (1794) 884567
FAX: +44 (1794) 884616
E-mail: [email protected]

LASCAR ELECTRONICS (HK) LIMITED
FLAT C, 5/FL., LUCKY FTY. BLDG.
63-65 HUNG TO ROAD
KWUN TONG

KOWLOON

HONG KONG
TEL: +852 2797 3219
FAX: +852 2343 6187
E-mail: [email protected]

Page 1 of 3

www lascarelectronics com

LASCAR ELECTRONICS INC.
3750 West 26th Street
Erie
PA 16506
USA
TEL: +1 (814) 835 0621
FAX: +1 (814) 838 8141
E-mail: [email protected]

Specifications liable to change without prior warning

SP 5-1200-BL

Issue 4

November/2003

M.C.

Applies to SP 5-1200/2

PO Box 770, Londonderry, NH 03053 1-800-821-0023
www.martelcorp.com

Advertising