Precision Control Systems StripIR 5306B - Manual (Page 14)

106837-001 Rev. 1 6-1
Section 6 – MAINTENANCE
The repair and maintenance of the Model 5306B includes replacement of the T3-style
lamp and quartz window and cleaning of the reflector.
6.1
LAMP REMOVAL/REPLACEMENT/INSTALLATION: The T3-style lamp
is installed into the Model 5306B heater when shipped from the factory. The following
procedure details the process to replace the lamps in the Model 5306B (reference Figure
6-1,& 6-2):
Note:

Remove all power from the heater BEFORE attempting to install/replace the
lamp.

Allow a minimum of ½-inch (12 mm) of slack in the lamp lead so that the lead
is not taut when inserted into the lamp terminal block.

Always take care to handle all lamps by the ceramic end seals and use clean
cotton or latex gloves to prevent contamination of the quartz lamp envelope.
1. Remove end-cover screws (1 per end cover).
2. Remove end covers on both ends of the heater.
Figure 6-1. Model 5306B End Cover Removal.