Precision Control Systems DryIR 6020 User Manual
Page 12
106920-001
Rev.
1
5-1
Section 5 – INSTALLATION
5.1
UNPACK AND CHECK FOR DAMAGE: Remove the Model 6020 heater
from its shipping container and associated packaging. Check the unit for any potential
damage due to shipping. In the unlikely event damage has occurred, keep all shipping
containers and materials in order to file a damage claim with the shipping company
responsible for shipping the unit.
5.2
MOUNTING THE HEATER: The Model 6020 heater should be mounted to a
framework or structure that is designed to support the weight of the heater and provide
stability to the unit. If a transport is being used in the application, the heater module
should be mounted so it is level with the transport and should be spaced from one inch
(25.4 mm) above the transport surface.
5.3
ELECTRICAL CONNECTIONS: The lamps of the Model 6020 are electrically
wired to an intermediate terminal block within the heater. An electrical schematic can be
found in the Appendix.
Each heater is supplied with an 8-foot (2.4 m) electrical cable. If ordered with the PC
option, this cable is directly hard wired into the Model 5620 power controller.
Figure 5-1. Model 6020 Pictured with Optional Mounting Kit