Revo REXT600-1 - Manual (Page 13)

- 8 -
CONTROL AND CONNECTIONS/DAY&NIGHT
INPUT / ALARM OUT TERMINALS - (UTP MODEL)
1 2 3 4
TP VIDEO OUTPUT D&N COM
IN GND
5
ALARM
OUT
6 7
RS 485+(RX)
RS-485
RS 485-(TX)
CLASS 2
+ DC 12V -
~ AC 24V ~
This terminal accepts a DC12V or AC24V power
source from a DC12V or AC24V ac +/-10% 60/50Hz +/- 1Hz.
Use Certified/Listed Class 2 power supply only.
In DC power, use the Adapter mode than DC 12V
500mA Capacity.
4) POWER INPUT TERMINAL
5) VIDEO OUT CONNECTOR
BNC : This BNC connector provides a 1.0Vp-p/75 ohms composite video Signal.
UTP : Unshielded Twisted Pair video Transmission for effective installation(option).
1PIN : TP VIDEO OUTPUT
2PIN : TP VIDEO OUTPUT
1) CAMERA CONTROL
6 PIN : RS 485+
- 7 PIN : RS 485
2) DAY&NIGHT INPUT Terminal
To select Day/Night mode using external equipment, connect control line
to the appropriate terminal.
DAY&NIGHT EXTERNAL INPUT (2pin)
It is the function that can be switched to DAY Mode or NIGHT Mode by receiving the
D&N on/off signal from external light sensor or IR LED LAMP. When D&N Mode is set
"EXT” on the OSD menu of the camera.
) ALARM OUT (5pin) 3
Motion detection signals are output through this port. (OFF : GND, ON : 3.3V)
4
3
GND
DAY&NIGHT INPUT
Open contact : DAY
Close contact : NIGHT
<WITH UTP MODEL>
*3Pin : Only D&N with ICR model option (DDN model : NC)
(Only D&N with ICR model option)