Satechi ST-A1500 HD Digital Indoor Flat Amplified TV Antenna (Powered by USB) w/ wall mount - Manual (Page 2)

SPECIFICATIONS
Frequency Range VHF: 47~230 MHz
UHF: 470~870MHz
Amp. Gain VHF: 20 ± 3dB
UHF: 17 ± 3dB
Noise Figure (Max.) < 2dB
O/P Return Loss < -8dB
RF Output Impedance 75 Ohm
RF Coaxial Cable 200cm x1 / 1.5C-2V
Power Inserter Frequency Range: 47~890MHz
Insertion Loss: < 2dB
DC Input: + 5V Via USB
Output Connector: F Male
INSTALLATION
Powering the antenna
(1) Take out the ST-A1500 antenna unit and check the accessories.
(2) Connnect the F connector to the antenna input of your Digital TV.
(3) Connect USB plug to the TV USB port to get 5V of power.
(4) Perform the channel scan. Please refer to the user manual of your Digital TV for
operational instruction.
(5) Check the signal quality. If you can not get a good signal reception, try to put the antenna in a
different position and try a different angle.
Coaxial Cable
Digital TV
Antenna placement:
Before the following step, please make sure that you have enough protection when
you drill into the wall and install the antenna.
1. Dry wall or Wooden wall mounted installation:
(1) Mark the fixing position with a pen or pencil.
(2) Take out the attached screws and use a screwdriver to fix them into a wall. Do
not fix the screws completely in - leave about 5mm for antenna placement.
(3) Fit the hook onto the antenna first.
(4) Fix the antenna unit on the screws.
2