Seametrics FT415 - Manual (Page 4)

20419 80th Ave. So., Kent WA. 98032 USA
Phone: 253-872-0284 Fax: 253-872-0285
www.seametrics.com 1-800-975-8153
Dimensions
Operation
To return to normal operation after entering settings,
press SET for a fourth time. The rate and total indicator
numbers should appear in the display. If the unit is con-
nected to an operating flow sensor, the larger-sized
digits indicate flow rate and the smaller-sized digits in-
dicate total.
Unless the unit has been ordered with the non-reset
option, a RESET prompt is constantly visible in the lower
right corner, above the up arrow key. Press this key at
any time to reset the totalizer to zero.
Battery Change
The expected average life of the battery is approximately
four years, with a range of 3-5 depending on the fre-
quency of the input. Pull the battery from its holder and
replace it with the new one. Note that when the battery
is removed, all of the settings previously entered will
be retained. However, the totalizer will reset to a previ-
ous total, which represents the last auto-backup (ap-
proximately one hour intervals.) If it is necessary to save
the exact current total at the time of the battery change,
save before removing the battery, by simultaneously
pressing the SET and up arrow keys. Then press SET
again, then again simultaneously press the SET and
up arrow keys.
4 of 4
Set Decimal Point. The third time the SET key is
pressed, a D prompt appears. Pressing the up arrow
key switches back and forth between no decimal place
and one decimal place.
Set Time Unit. The fourth time the SET key is pressed,
a blinking arrow appears. Press the up arrow key to
select S (seconds), M (minutes), H (hours) or D (days).
FT415
Sensor-Mount
FT415
with Wall Mount Brackets
2.78"
2.57"
SET
3.93"
4.52"
3.93"
2.06" 2341678.9
10.5
AR
CH
IVE
D