SHIMPO FGS-250PV - Manual (Page 10)

10
Modifying the Force Gauge Plate for Load Cell Use
The force gauge plate should be removed from the mounting platform and reattached as shown below.
4. LC-50S/100S/200S
5. LC-500S
Attaching the DRI Force Gauge Plate and Force Gauge
Items included with the DRI force gauge plate are:
• (1) DRI mounting plate
• (2) Threaded spacers
• (2) Spring washers
• (2) Flat washers
• (2) Plate to threaded spacer mounting screws
• (3) DRI mounting screws
Attach two threaded spacers to the right side of the test stand mounting holes shown in figure 1 below.
Place one spring washer and one flat washer on each of the plate to threaded spacer mounting screws. Insert
through the two holes on the short squared end of the mounting plate. Fasten the screws to the two installed
threaded spacers. (See figure 2 for positioning details).
Mount the DRI to the plate using the DRI mounting screws (provided).
Figure 1 Figure 2