SHIMPO CAG-2000 1 Channel - Manual (Page 19)

17
’ Press or to select the number of the program to be used, and press
to determine the selection. The instrument ends the change program mode
and returns to the measure mode.
Fig. 8-3. Selecting and determining program number.
X A program number change calls for mastering. A measuring nozzle change may
call for the zero position and sensitivity of the air circuit to be adjusted with the zero
and sensitivity adjustment knobs, respectively.
X When setting any item, select the number of the program to be used before
changing to the set mode.
X When its power is turned on, the instrument starts at the program number selected
last.
2 1 3
S ET MAS
ENT
RST
SET MAS
12.0
2 1 3
SE T MAS
ENT
RST
S ET M AS
2
2 1 3
SE T MAS
ENT
RST
S ET M AS
7
Determines
selection
Increments
program number
Decrements
program number