Alcatel-Lucent 8950 AAA - Manual (Page 428)

............................................................................................................................................................................................................................................................
List of Server Commands Server Diagnostics and Control Commands
24-2 365-360-001R6.0
Issue 1, December 2008
............................................................................................................................................................................................................................................................
List of Server Commands
About Server Commands
This section describes each command by listing the following components:
• Command name
• Brief description of the command
• Command format containing syntax and arguments
• Table of arguments, if any
Argument description
The following list describes the special symbols used within the command format line of
each description.
• Arguments within square brackets ([ ]) are optional.
• Arguments within angle brackets (< >) are variables that represent an appropriate
value.
• Arguments separated by a pipe symbol (|) indicate that only one of the arguments
can be used for each execution of the command.
cache
The cache command is used to add, count, delete, or list a cache entry.
Command Format:
cache add KEY[NAME=VALUE][NAME=VALUE]...|count KEY|delete
KEY|list KEY|dump KEY|save FILE|load FILE
The following ][section lists the cache commands and their arguments:
cache add
Description: Adds an entry to the cache.
Command Format: cache add [-live <sec>][-idle<sec>] <key> [NAME-
VALUE]
-live <sec> The amount of time, in seconds, for this entry to
reinforce the
-live.
-idle <sec> The amount of time, in seconds, to remove the entry
from the cache if the entry has not been updated.
key The name of the cache entry.
NAME-VALUE A list of attribute=value pairs.