Thermo Fisher Scientific EcoScan Temp 4/5/6 - Manual (Page 5)

1
1. INTRODUCTION
1.1 Introducing the economy series
Thank you for purchasing the Temp 4/5/6 meter. These microprocessor-based
handheld meters are economical and easy to use. They are available in three
models:
• The Temp 4 uses *YSI 400 series thermistor temperature sensor
• The Temp 5 uses 100K thermistor temperature sensor
• The Temp 6 uses PT100 ohm (Platinum) RTD temperature sensor
All Temp 4/5/6 meter series feature:
• Large LCD for clear and easy reading
• Readings
in o C and o F (selectable)
• Minimum and maximum temperature display
• Minimum and maximum hold mode
• Low battery indicator
• Hold function, freezes measured reading
• User calibration - offset adjustment
• Non volatile memory backup; calibration and other information remain if
battery is disconnected
• Temp 5 meter allows user selection of most suitable temperature curve for
its thermistor sensor
This instruction manual is organised for quick reference with step-by-step
procedures that give you thorough review of the various features and meter
operations.
Included with your meter are a temperature sensor (Temp 5 only), rubber boot,
4 alkaline “AAA” batteries, an instruction manual and a warranty card. To order
other accessories, please refer to Section on Accessories for more information.
* YSI is a registered trademark of Yellow Springs Instruments.