Document Outline

• 1. Introduction
  • 1.1 Before You Begin
  • 1.2 Intended Use
  • 1.3 Safety Instructions
  • 1.4 Taking Out of Service / Correct Disposal of the Unit
• 2. Getting Started
  • 2.1 Description of Instrument
  • 2.2 Measurement and Control System
  • 2.3 Overview
    • 2.3.1 Display Overview
    • 2.3.2 Key Functions
    • 2.3.3 LED Indicators
    • 2.3.4 Security Codes
    • 2.3.5 Menu Overview
• 3. Assembly and Installation
  • 3.1 Mounting the Unit
  • 3.2 Connection Diagram
• 4. Normal Operation
  • 4.1 Measurement Mode
• 5. Calibration Mode
  • 5.1 Entering Calibration Mode
  • 5.2 Calibration
    • 5.2.1 One-Point Calibration
    • 5.2.2 Two-Point Calibration
  • 5.3 View Probe Condition
• 6. Setup Mode
  • 6.1 Enter Setup Mode
  • 6.2 Electrode Offset Settings (OFS)
  • 6.3 Temperature Setting (SET °C°F)
  • 6.4 Control Relay A / Relay B Settings (SP1/SP2)
  • 6.5 Controller Settings (CNTR)
  • 6.6 Current Output 1 Settings (CUR 1)
  • 6.7 Current Output 2 Settings (CUR 2)
  • 6.8 Wash Relay Settings (WASH)
  • 6.9 Configuration Settings (CNFG)
  • 6.10 Calibration (CAL)
• 7. Relay Modes
  • 7.1 View Relay Set Points
  • 7.2 Manual Relay Mode
• 8. Technical Specifications
  • 8.1 General Specifications
  • 8.2 Specifications for Wall Mount Version
  • 8.3 Specifications for Panel Mount Version
• 9. Accessories
  • 9.1 Replacement Unit
  • 9.2 Other Accessories
• 10. General Information
  • 10.1 Warranty
  • 10.2 Packaging / Scope of delivery
  • 10.3 Return of goods
  • 10.4 Guidelines for returning unit for repair
• 11. Appendices
  • 11.1 Appendix 1 – Replacing Fuse
  • 11.2 Appendix 2 – Dissolved Oxygen Values
  • 11.3 Appendix 3 – Simple Explanation on the Function of Hysteresis
  • 11.4 Appendix 4 – General Instructions Concerning Controller Setting
  • 11.5 Appendix 5 – Abbreviations Used in LCD
• ts_alpha_do2000ppgAmend1.pdf
  • ts_alpha_do2000ppg-42