Dwyer A-464 - Manual (Page 2)

Panel Mounting
Panel mounting is accomplished following most of the steps
listed for wall mounting. Some of the differences are listed
below:
• Use the appropriate length and type of mounting screws for se-
curing the mounting plate (A1) to the panel.
• If the high and low references are remote from the panel, con-
nect the pressure sensing tubing to the appropriate ports on the
gage.
• If clearance behind the gage is a concern, the side ports on the
gage may be used.
To use the side ports, install the factory supplied plugs on the
back ports and install the barbed fittings supplied with the gage
on the side ports.
Note: Install the barbed fittings on the side ports after the gage
is mounted on the panel.
A3
LOW
HIGH
LOW
HIGH
A1
A2
INSTALLATION DIAGRAM
DWYER INSTRUMENTS, INC.
Phone: 219/879-8000 www.dwyer-inst.com
P.O. BOX 373 • MICHIGAN CITY, INDIANA 46361, U.S.A. Fax: 219/872-9057 e-mail: [email protected]
©Copyright 2010 Dwyer Instruments, Inc. Printed in U.S.A. 7/10 FR# 443289-00 Rev. 4
A-27-M:A-27-M 7/16/10 9:37 AM Page 2