Innotech Genesis II Digital Controller (v5) - Manual (Page 60)

Genesis II Installation Instructions
Page 60 © Mass Electronics Pty Ltd 2010 Edition 2.0 dated 06/12/2013
3-4.10 GENII MZSAH REM Multi Zone Station A/H Module
The GENII MZSAH REM Multi Zone Station A/H Module is powered by 24VAC ±10% @ 50/60Hz. Power
Consumption is 3VA maximum.
The GENII MZSAH REM mounts into a standard electrical wall plate. The only connections to the
GENII MZSAH REM are 24VAC power and the RS485 Comms link. Locations of electrical terminals are
shown in Figure 3-14, which is a rear view of the module.
When all connections have been made, protect the module from dirt and moisture by covering it with
plastic but do not mount the module in the wall plate until commissioning is completed. This is to
allow addresses to be set as part of the commissioning process.
END OF
CABLE
JUMPER
RS485
COMMS
CONNECTIONS
POWER
Figure 3-14: GENII MZSAH REM Multizone Station A/H Module