Metpar Phenolic User Manual
Page 5
STEP 4A
STEP 4A -- Attach Stile FP500
Attach Stile FP500
A. Place plastic anchors into the floor holes.
B. Over each floor anchor place these items in the
following order; one (1) shoe clip and one (1)
bracket. Fasten into anchor with #12 x 2 ½”
screw.
C. Place stile over L-brackets and push panel into U-
brackets up to screw heads. Fasten one #14 x
5/8” sheet metal screw through each L-bracket.
D. Plumb stile, place wedge at top rear between panel
and wall.
E. Fasten U-brackets to panel. Remove panel
support.
STEP 4B
STEP 4B -- Attach Stile CH700
Attach Stile CH700
A. On each 3/8” diameter ceiling stud, place these
items in the following order; one (1) shoe clip, one
(1) rectangular washer, two (2) nuts and one (1)
washer.
B. Place stile over studs and place on each stud one
(1) clamp, one (1) round washer and one (1) nut.
C. Bottom of panel and bottom of stile should align
and be even.
D. Plumb stile, place wedge at top rear between panel
and wall.
E. Fasten U-brackets to panel. Remove panel
support.
STEP 4C
STEP 4C -- Attach Stile FT700
Attach Stile FT700
A. Place expansion shields into floor holes.
B. Screw (hand tight) 3/8” studs into shields.
C. On each stud place these items in the following
order; one (1) shoe clip and one (1) washer.
D. Screw one (1) 3/8” nut onto each stud. Tighten
nuts to expand anchor.
E. Place one (1) nut and one (1) round washer onto
each stud.
F. Lower the stile over the studs and place on each
stud these items in the following order; one (1)
clamp, one (1) round washer and screw on one (1)
nut.
G. Top of stile and top of panel should align and be
even.
H. Plumb stile, place wedge at top rear between panel
and wall.
I. Fasten U-brackets to panel. Remove panel
support.
Page 4