Prochem Everest EFI - Manual (Page 11)

OPERATIONS
EVEREST EFT 980197 06/30/04 3-2
INSTALLATION REQUIREMENTS
DEALER RESPONSIBILITY
NOTE: Your distributor from whom you
purchased this mobile cleaning unit is
responsible for the correct installation of this
machine. The dealer is also responsible for
initial training of your operators and
maintenance personnel in the proper operation
and maintenance of this unit.
1. The unit should NOT be mounted in any motor
vehicle of less than 3/4 ton capacity.
The console with waste tank and accessories must
NOT exceed the vehicle's axle weight limit.
2. If mounting in a trailer, make certain that the
trailer is rated for the total weight of the UNIT
AND TRAILER. Electric or hydraulic brakes
should be provided, and a strict compliance with
any State and Federal vehicle laws must be
maintained. Install unit on tandem axel trailer
only. Single axle trailers are not recommended.
3. The vehicle tires should have a load rating
above the combined vehicle and unit weight.
4. We do not recommend using flooring materials
that absorb water. This could result in rust and
corrosion of the vehicle floor.
5. Padding under rubber floor mats should be
removed before installing this unit.
6. We highly recommend using a drip tray under
the console (Part #790552).
7. If using a trailer, the console should be
positioned so that it balances properly with
respect to the axle. Ten percent (10%) of the
overall unit weight should be on the tongue.
Example: If loaded trailer weight is 2,000 lbs.,
tongue weight needs to be a minimum of
200 lbs. to tow properly.
FUEL REQUIREMENTS 2 . FUEL
REQUIREMENTS
Use unleaded gasoline ONLY. DO NOT use any
gasoline additives. We recommend the use of clean,
fresh, unleaded gasoline intended for automotive
use. High octane gasoline should NOT be used with
the engine on this unit.
ENGINE OIL REQUIREMENTS 3 OIL
REQUIREMENTS
Use high quality detergent oil of at least API
(American Petroleum Institute) service class SF or
SG. Select the viscosity based on the air
temperature at the time of operation as shown in the
following table. NOTE: Using less than service
class SF or SG oil or extending oil change intervals
longer than recommended can cause engine
damage.
TEMPERATURE RANGE EXPECTED BEFORE NEXT OIL CHANGE
°F -22 -4 14 32 59 104
°C -30 -20 -10 0 15 40
5W-20
10W
5W-30
10W-30, 10W-40, 10W-50, 15W-40, 15W-50
20W-20, 20W-40, 20W-50