Prochem Trident Dehumidifier User Manual
Page 15
15
Operations
Exhaust Ducting
1.
Place quick-ducting band over lay-flat duct
approximately 1 foot from end.
2.
Slide ducting 3 or 4 inches over front exhaust
nozzle, make sure it is even all around.
3.
Secure in place by sliding quick-ducting band
along ducting and over exhaust ducting flange.
4.
Verify that ducting is sandwiched between machine
exhaust nozzle and quick-ducting band and even
all around making a good seal.
5.
Position machine and ducting in desired orientation
and location.
6.
Plug machine into power source.
7.
Switch machine on.
8.
Observe ducting as air starts to flow through it,
ducting may move around.
Intake Ducting
1.
Unwrap cord from cord storage area.
2.
Place a quick-ducting band over ridged spiral duct
about 1 foot from end.
3.
Slide ducting 3 or 4 inches over top intake nozzle,
make sure it is even all around.
4.
Secure in place by sliding quick-ducting band
along ducting and over the intake ducting flange.
5.
Verify that ducting is sandwiched between machine
intake nozzle and quick-ducting band.
6.
Position machine and ducting in desired orientation
and location.
7.
Plug machine into power source.
8.
Switch machine on.
9.
Observe ducting as air starts to flow through it,
ducting may move around.
86352290 Trident LGR Dehumidifier