ScyTek Electronics Galaxy 5000RS-DBP - Manual (Page 8)

2-way LCD Remote Transmitter Description
Depending on the model chosen, the Galaxy 5000RS-DBP-2W Series will be supplied with one or two 2-way
LCD Remote Transmitters, offering increased range and confirmation of any activated features.
Page 1
Button 1 Arms and Locks the system and when held for 5 seconds, activates the system’s Panic feature.
Button 1 also locks the doors when the system is in Valet Mode.
Button 2 Disarms and Unlocks the system. Pressing Button 2 again operates the Passenger Unlock feature
( if installed). Button 2 also unlocks the doors when the system is in Valet Mode.
Button 3 Activates the Auxiliary 1 output normally used for trunk release (note trunk icon on button).
Button 4 Activates the Remote Start feature.
Button 5 is the Confirmation, Programming and the Page Shift button. Quickly pressing button 5 will activate
the Page 2 function. Pressing button 5 for 2 seconds activates the system’s confirmation feature which will
then display the current status of the system ( armed, disarmed, engine running, etc.).
Page 2
Button 1 Silently Arms/Locks the system.
Button 2 Silently Disarms/Unlocks the system.
Button 3 Activates the Auxiliary 2 output.
Button 4 Aux 3 or Factory Rearm output.
Button 5 Not Implemented.
Page 3 & 4 are used as Page 1 & 2 for second car operation
Adding/Replacing 2-way LCD Transmitters
When adding a 2-way LCD transmitter to the system ( maximun of two LCD Transmitters total) Any
previously stored transmitter will be erased if it is not programed within the following sequence.
Follow these steps:
1. Turn the ignition key On Off, On Off, On Off, and back On. (Key On 4 times)
· 3 seconds Later the siren/horn will chirp/honk 4 times.
2. Press and hold the Override switch for 5 seconds .
· The siren/horn will chirp/honk 4 times.
· The LED will illuminate.
Button 1 Button 2
Button 3
Button 4
Button 5
Page 4 - Galaxy 5000RS-DBP