Sterlco 4300 Series Stainless Steel Condensate Pumps - Manual (Page 8)

Page 8 of 10
9037-891 9037-891
SERVICE SERVICE
BULLETIN BULLETIN
FLOAT & LINK POSITIONS
PRESSURE: In the use of any of these Float Switches, the pressure limit within the closed tank must not exceed 100 lbs.
MOTOR PROTECTION: A float switch of this type does not afford motor protection, however it is quite frequently used as a pilot to operate a
starter providing these desirable features. The Square D Co. manufactures a complete line of motor protective switches, information on which will
be sent upon request.
REVERSE ACTION: To change, relocate operating link as shown in table 2810-D22 above to the opposite slot in base plate and corresponding
hole in adjusting plate (Item 5).
TYPICAL WIRING DIAGRAMS
ELECTRICAL RATINGS (HORSEPOWER)
Voltage Single Phase AC Polyphase AC DC
115 …………………………………….…………. 2 HP …………………..…..3 HP …………………………………… ½ HP
230 …………………………………….…………. 3 HP ……………………....5 HP …………………………………… ½ HP
460/575 ………………………………………….. ……………………….1 HP ……………………………………
32 ………………………….……………………... ………………………. …………………………………… ¼ HP
Control Circuit Rating: A600