Timeguard RTS114 - Manual (Page 6)

6 5
Zer
ofour – November 2013
3.2 Half day and day omit programming and 7 day control setting.
This is required only if the programme set on the 24 hour ring is not needed for one or more half
days. An example is shown in fig 5 where the requirement is to have no operation on Thursday
(day 4) afternoon and all day Friday (day 5). The 7 day switch segments between 4 and 4 (midday
Thursday) as well as between 5 and 6 (midnight Friday) have been turned anti-clockwise with a
small screwdriver until the segment slot is aligned radially
so that the 7 day output will be
changed as each of these segments passes the time marker. Excessive force used to turn a
segment anticlockwise will cause damage.
The 7 day (blue) output will also need to be set manually in the right initial condition. In the
example shown in fig 5 when the time marker points within the period midday Thursday – to
midnight Friday the setting will be
•
– OFF and outside this time period ■ – ON. This is achieved
by using a screwdriver to turn the 7 day control in a clockwise direction until the slot points to
a
•
for OFF or a ■ for ON. In the situation shown in fig 5 the control needs to be set ON.
Finally ensure permanent override indicator is set to AUTO. The 7 day control must only be
rotated in a clockwise direction. The screwdriver slot in the control is shaped to
prevent rotation in the opposite direction.
3.3 Override to next programme change.
The red 24 hour control can be turned anticlockwise by one click. This will change the
present output of the RTS unit and will last until the next programme change.
The 7 day control must only be rotated in a clockwise direction. The screwdriver
slot in the control is shaped to prevent rotation in the opposite direction.
3.4 Permanent Override ON.
The RTS unit can be permanently overridden ON by pressing the red button on the outside of
the case and transparent cover adjacent to the 7 day and 24 hour controls. The override can be
terminated by pressing the button again. The state of the timeswitch either permanently ON
or in Auto is indicated by the pointer adjacent to the 7 day and 24 hour controls.
7 day output
control (blue)
OFF at 1200 (blue tappet)
ON at 0900 (red tappet)
AM marker bar
ON at 2000 (red tappet)
OFF at 2200 (blue tappet)
24 hour output
control (red)
Permanent override
indicator
Segment set to change
7 day output
Time marker
Fig 5