Timeguard ZV700 - Manual (Page 10)

9 10
vi Repeat steps i to v to set the remainder of the 5 programme ON/OFF times and
day(s) as required. Note: Any unused ON/OFF programmes must be left blank and
should be skipped by pressing the <Programme> button until the display shows
normal operating mode. Do not programme ‘0’s into unused programmes.
IMPORTANT After setting a clock time which falls within a programmed ON
period, the unit will not switch ON. Press the <Change> button to switch the unit
ON. After this the unit will operate normally to the programmes set.
12 Programme Review
To fast review the set programmes or for quick exit to normal operating mode –
press and hold down the <Program> button.
Normal review can be carried out by pressing the <Program> button briefly which
reviews the clock time and day with the whole display flashing. Further brief
pressing of this button reviews the programme ON and OFF times and day(s) in
sequence again with the whole display flashing.
13 Making Changes to Clock Time and
Programmes (Initiating Programme Mode)
This is required when making changes to the clock time/day or programme times/
days and can be initiated any time during the normal operating mode. Press the
<Program> button briefly and the clock symbol, day flag, hrs and minutes symbols
on the display will flash – this is programme review mode. Further brief pressing of
the <Program> button will display the ON and OFF programmes in sequence.
Having reached the clock time/day or programme time/day(s) requiring change,
press the <Change> button briefly to initiate programme mode and then follow
steps 10 and 11 as required. Having completed the change press and hold down
the <Program> button until normal operating mode is reached and then release.
14 Cancelling Programmes
Any ON/OFF programme can be cancelled by clearing its ON and OFF time.
Follow step 13 and when into the ON and OFF programme to be cancelled press
the <Change> button briefly and the day dot(s) will flash, press the <Program>
button briefly to select the hours and press the <Change> button until the hour
digits show -- --: then press the <Program> button briefly to clear the programme
time. The display will show the hour and minute dashes and ON or OFF flashing.