Parts included, Tools and parts needed, Selecting a location – Timeguard SLFM360L User Manual
Page 4
3
4
Parts included
• PIR Sensor unit.
• Instruction manual. Please keep safe for future reference.
• Accessory Pack. Includes wiring cover, 2 x cable clamps, 4 x clamp
screws and 1 x lens mask sticker. Tools and parts needed
Tools and parts needed
• 3 core flexible cable.
• Electric/hand-held drill & bits.
• 75mm or 3 inch diameter hole cutter.
• Terminal or Electricians screwdriver.
• Small philips screwdriver.
• Wire cutters.
• Suitable mains interconnect cable.
This product is suitable for indoor use only.
Connected load must not exceed maximum 2400W Incandescent/Halogen,
500W Fluorescent or 150W CFL/Low Energy. LED lamps <10W lamps,
Max. 10. LED lamps >10W <32W, max 5. sets.
Do not attempt to install if you are suffering from nausea or dizzy spells
or on medication with similar side effects.
Not suitable for use with discharge lighting.
Selecting a location
The motion detector has a number of detection zones, at various
vertical and horizontal angles as shown (see diagram A).
A moving human body needs to cross/enter one of these zones to
activate the sensor. The best all-round coverage is achieved with the
unit mounted at the optimum height of 2.5m.
Careful positioning of the sensor will be required to ensure optimum
performance. See diagram A detailing detection range and direction.