Timeguard 200.0.000 - Manual (Page 8)

48
4. Start-up
The detectors are supplied ready for operation with a factory setting of re-
commended standard values. The QuickSet plus service remote control for
starting-up the system is optionally available. With the remote control all po-
tentiometer values can be set from a distance.
4.1 Settings for switching contact «Light»
Potentiometer
When changing a brightness switching value or a switch-off delay time with
the potentiometer concerned, the presence detector switches to the service
phase for a period of 10 min. (see section 4.3).

Brightness threshold «LUX»
Scale
Transfer zones (no working area) approx. 2
Working areas (small offices) approx. 4
Deactivation of brightness measurement «on»
●
●
●
 
PresenceLight 360