TOHO ELECTRONICS TTM000 - Manual (Page 34)

34
6.12 Example of LRC calculations
Following is an example of calculating LRC with VisualBasic6.0.
Variables are declared as shown below.
VisualBasic6.0 cannot use code-free variables. It therefore uses code-equipped 16-bit integer
variables as data. Similarly, the LRC calculation results are entered into code-equipped 16-bit
integer variables.
Dim LRC As Integer
Dim i, arry_count As Integer
Dim lrc_arry(128) As Integer
Then enter calculable data into the 1rc_arry(), and enter the number of data items
into the arry_count
After that, run the following program to cause the calculation results to enter the LRC.
For i = 0 To arry_count
LRC = (LRC + lrc_arry(i)) And &HFF
Next
LRC = ((Not LRC) + 1) And &HFF
If the error code is calculated as 12H as an example, affix a "1" or "2" at the end of the message.