Ultravation Right-Angle Design Non-Photronic Media Air Cleaner - DC-IH-0212 User Manual
Page 2
2
`
Shipping and Packaging List:
• Filter Housing including 2 Access Doors
• MERV-11 Media Air Filter
• 1-
Adjustable
Top
• 4- ¾ inch 5/16 self tapping sheet metal screws
• 8’ x ½” Installation foam
• 1- Door Handles with hardware
Introduction and Applications:
This Ultravation Media Air Cleaner is a high efficiency air
filtration unit designed to remove dirt, dust, pollen, and
other microscopic particles from the air that circulates
through it. By adding this device to your HVAC system, you
are helping to create a cleaner indoor living environment for
your whole household.
The filter works by trapping particles in the pleats of the
media filter. With an extra large surface area, the filter
allows for maximum dirt holding capacity and a long, useful
filter life with minimum air flow restriction.
This media air cleaner is to be installed in a forced air
heating, cooling and ventilation system.
It should be installed so that all the system air is circulated
through the filter. The air cleaner will only filter the air that
is circulated through it. For maximum filtration effect, set
your blower to operate continuously.
Installation Requirements:
The desired location for installation of the Ultravation Right
Angle Media Air Cleaner is in the return air next to the
blower compartment. In this location, the blower motor and
internal components will be kept clean.
By installing the air cleaner in this location (upstream from
the cooling coils) you also will assure that the cooling coils
of the air conditioning system will be kept clean. This
increases coil life, improves system efficiency, and reduces
maintenance costs.
Once the Ultravation Right Angle Media Air Cleaner is
installed, it is very important to maintain the unit by
changing the filter periodically so as not obstruct airflow,
damage components or increase energy costs.
The Ultravation Right Angle Media Air Cleaner has been
designed for use in conjunction with Highboy HVAC
systems.
The duct opening of this unit is adjustable for either an 8” x
24” duct, 10” x 24” duct. –or- 12” x 24” duct.
Just remove the three sheet metal screws on the top,
adjust the flange, and reattach.
Do not install this unit in the supply duct.
Be sure to plan adequate space for filter replacement.
Before installation is complete, seal all joints and seams
with duct tape or caulking.
Gasket material included to optimize IAQ performance.
Note: Handle fits either door. A Phillips screw driver will be
required to install the handle. Handle holes are behind the
label on either door, depending on the orientation of the
installation.