Aroma AHG-2233 - Manual (Page 10)

7
Helpful Hints
1. Please remember that the Flip Grill heating plate is coated with a nonstick
surface and that heat-safe plastic utensils should always be used.
2. If you’re grilling vegetables, fish or lean meat, it’s best to spray the grilling
surface with a cooking spray. If you are grilling meat with any amount of fat
or if the food has been marinated, there is no need to pre-treat the grill.
3. For best results, allow the grill/griddle plate to preheat for 5-7 minutes before
grilling.
4. If using a marinade with oil, place grill near an exhaust hood. Oil or fats will
produce some smoke.
5. Do not leave the grill on to “burn off” any food or drippings remaining on the
grill surface after cooking. In addition to causing unnecessary smoke this can
reduce the life of the nonstick coating and may present a fire hazard.
Problem Solution
The temperature probe
appears to turn on and
off during cooking.
- When the thermostat reaches the desired temperature, it
will temporarily shut off to avoid overheating. This is normal.
It will turn back on as needed to prevent the temperature
from dropping below the selected setting.
- Double check that the grill/griddle plate has not become
dislodged from the base. If the heating plate and
temperature probe are not properly situated on the base,
the built-in safety switch will automatically cut power to the
heating element. Allow to cool, then check the alignment
of the parts. Operation will resume normally when all
pieces are properly assembled.
My Raclette cheese is not
melting.
It is best to allow the cheese to melt a few minutes under the
heated grill before cooking other foods, as Raclette cheese
takes a while to melt. Also, a higher setting (8-10) is needed
when making Raclette.
Also, removing trays from beneath the heating plate and
placing them on the heated griddle for 30-40 seconds will
help to speed up the melting process.
Should I use the stainless
steel tray when I’m not
making Raclette?
Yes, it is best to use the Flip Grill with the stainless steel tray in
place at all times.
Troubleshooting