Brother PT-9200DX - Manual (Page 32)

28
Power button light
Lights up in green
Flashes in green
Lights up in orange
Flashes in orange
Flashes in red
(Correct the problem, and then try printing
again.)
Lights up in red
(Correct the problem, and then try printing
again.)
Description/Remedy
• The P-touch is operating normally and is in stand-by.
• The P-touch is receiving data from the computer correctly.
• While in stand-by, the P-touch detected that the tape cassette was not
inserted correctly. Correctly insert the tape cassette. Printing will begin
when the tape cassette is correctly inserted.
• The tape compartment cover is not completely closed. Close the tape
compartment cover.
• While receiving data, the P-touch detected that the tape compartment
cover was not completely closed or that the cover was opened. Close
the tape compartment cover. Printing will begin when the tape com-
partment cover is closed.
• While printing, the P-touch detected that a tape cassette was not in-
serted or that the tape cassette ran out of tape. Insert a tape cassette or
replace it.
• Before or during printing, the tape compartment cover was opened.
Close the tape compartment cover.
• A data transmission error occurred. After about five seconds, the P-touch
will return to stand-by (the power button will light up in green).
• Turn off the P-touch, and then turn it on again.
If the power button continues to light up in red, contact your service
representative.
Monitoring the P-touch Status
You can determine the status of the PT-9200DX from the power button light.
PT-9200DX status