Brother XR53 - Manual (Page 23)

22
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
1
6
While lightly holding the thread, turn the
needle threader lever toward the front of
the machine (toward you). The hook will
pull the thread through the needle.
7
Raise the needle threader lever.
8
Pull the loop of the thread passed through
the eye of the needle toward the rear of
the machine.
1 Loop of thread
CAUTION
9
Raise the presser foot lever.
0
Pass the end of the thread through the
presser foot, and then pull out about 5 cm
(2 inches) of thread toward the rear of the
machine.
1 5 cm (2 inches)
Note
● If you incorrectly feed the thread you may
cause sewing problems.
Drawing up the lower
thread
1
While lightly holding the end of the upper
thread, slowly turn the handwheel toward
you (counterclockwise) by hand to lower
and then raise the needle.
2
Pull on the upper thread to draw up the
lower thread.
1 Upper thread
2 Lower thread
● Be careful not to pull on the thread with
force or it may bend the needle.
● If the thread does not pass through the
eye of the needle, start from step
3
again.
1
1
1
1
2
2