Brother MFC-3100C - Manual (Page 37)

A S S E M B L Y A N D C O N N E C T I O N S 2 - 10
BHLMFC-US-MFC3100C-FM5.5
8 Repeat Steps 5 to 7 to install each
color ink cartridge.
9 After installing all ink cartridges,
close the top cover and control
panel cover until they click into
place. Your MFC will enter a
“head cleaning” cycle for
approximately four minutes.
Caution
Make sure the paper is loaded in the multi-purpose sheet feeder. The LCD
shows
CLEANING . After the cleaning cycle is finished, the LCD shows
PRESS FAX START .
10 Press Black Fax Start. The MFC starts printing the Print Quality Check Sheet
(only during initial ink cartridge installation).
The LCD shows:
11 Follow the instructions printed on the sheet.
Caution
■ DO NOT remove ink cartridges if you do not need to replace them. If you do so, it may
reduce the ink quantity and the MFC will not know the quantity of ink left in the cartridge.
■ DO NOT shake the ink cartridges. If you do so, the ink may spill when you take off
the sealing tape. If ink stains your body or clothing, wash with soap or detergent
immediately.
■ If you mix the colors by installing an ink cartridge in the wrong color position, you
must clean the print head several times after correcting the cartridge installation and
before you start printing.
■ Once you open an ink cartridge, install it in the MFC and use it up within six months
of installation. Use unopened ink cartridges by the expiration date written on the
cartridge package.
■ DO NOT refill the ink cartridges. Attempting to use refilled cartridges and using
incompatible inks may cause damage to the print head in this machine and such
damage will not be covered by warranty. Warranty coverage does not apply to
problems caused by the use of 3rd party ink or 3rd party ink cartridges. Use only
genuine Brother ink cartridges.
Note
If INK EMPTY shows on the LCD after you install the ink cartridges, check
to make sure the ink cartridges are installed correctly.
I S S T E P “ A ” O K ?
1 . Y E S 2 . N O