Brother DCP-130C - Manual (Page 10)

Setting Up the Machine
8
STEP1
5 Print quality check
1
After the cleaning cycle is finished, the LCD
shows:
Set Paper and
q
Press Start
2
Make sure paper is loaded in the paper tray.
Press Color Start.
The machine starts printing the Print Quality
Check Sheet (only during initial ink cartridge
installation).
3
Check the quality of the four color blocks on the
sheet.
(black/ yellow/ cyan/ magenta)
Improper Setup
Avoid touching the printed surface of the
paper immediately after printing, the surface
may not be completely dry and may stain your
fingers.
4
The LCD shows:
Is Quality OK?
q
a Yes b No
5
Do one of the following:
„ If all lines are clear and visible, press a
(Yes) to finish the quality check.
„ If you can see missing short lines, press b
(No) and go to step 6.
6
The LCD asks you if the print quality is OK for
black and color. Press a (Yes) or b (No) .
Black OK?
q
a Yes b No
Color OK?
q
a Yes b No
After pressing a (Yes) or b (No) for both black
and color, the LCD shows:
Start Cleaning?
q
a Yes b No
7
Press a (Yes), the machine will then start
cleaning the colors.
8
After cleaning is finished, press Color Start.
The machine starts printing the Print Quality
Check Sheet again and goes back to step 3.
6 Choosing your language
(Canada only)
1
Press Menu.
2
Press a or b to choose 0.Initial Setup
Press OK.
3
Press a or b to choose 0.Local Language
Press OK.
4
Press a or b to choose your language.
Language:English
5
Press OK.
6
Press Stop/Exit.
OK Poor