Brother HL-5050 - Manual (Page 82)

NOVELL NETWARE PRINTING 6 - 18
YL4US_FAX2800MFC4800-FM5.5
21 Execute the BRCONFIG from the Windows ® menu.
Select the print server from the list of print servers. When you
get the message that the print server is connected, press the
ENTER key and type the default password of
access in
response to the # prompt (the password will not echo), and then
press the ENTER key again in response to the ENTER
Username> prompt. When you get the Local> prompt, type:
SET SERVICE service TREE tree
SET SERVICE service CONTEXT Context
■ Where tree is the NDS tree name.
■ Where context is the name of context where the print server
resides.
■ Service is the name of the service assigned by NetWare print
server name (where the default services are
BRN_xxxxxx_P1 for the Brother printer, where xxxxxx is
the last six digits of the Ethernet address (MAC address)).
■ You can also enter the TREE and CONTEXT name using
your web browser, by connecting to the Brother print server
using the TCP/IP protocol and selecting the NetWare
protocol configuration.
22 Use the BRCONFIG command or TELNET command: SET
NETWARE RESCAN to force the print server to rescan for file
servers, or power cycle the printer.
The same service assigned by NetWare print server cannot
be used for both queue server mode and remote printer
mode. If you want to enable remote printer capabilities on a
service other than the default NetWare service, you must
define new services that are enabled for NetWare and for the
desired port. Refer to Appendix in this manual for information
on how to do this.