Brother MFC-9130CW - Manual (Page 23)

20
4
4
Wi-Fi Direct network terms
4
Group Owner (G/O)
4
If you set Group Owner to On, your Brother machine serves as an access point when you configure a Wi-Fi
Direct network. The G/O assigns an SSID name, password and IP address for the Wi-Fi Direct network. The
default setting is Off.
Device Information
4
Device Name
4
You can check the device name of the machine in the Wi-Fi Direct network environment. The device name
will be shown as **HL-xxxx, **MFC-xxxx or **DCP-xxxx (where xxxx is your model name and ** is the
character string assigned by your Brother machine).
SSID
4
This field displays the current Wi-Fi Direct network SSID name. The display shows up to 32 characters of the
SSID name.
IP Address
4
This field displays the current IP address of the machine assigned by the G/O.
Status Information
4
Status
4
This field displays the current Wi-Fi Direct network status. When your machine is a G/O, it displays the
message G/O Active(**) (where ** is the number of devices). When your machine is a client, the machine
displays the message Client Active. If you see Off, your machine's Wi-Fi Direct interface is disabled.
Signal
4
This field displays the current Wi-Fi Direct network signal strength.
Channel (For HL-3140CW, HL-3150CDW and HL-3170CDW)
4
This field displays the current Wi-Fi Direct network channel.
Speed (For HL-3140CW, HL-3150CDW and HL-3170CDW)
4
This field displays the current Wi-Fi Direct network speed.
Glossary
4