Brother MFC-8660DN - Manual (Page 83)

Remote fax options
69
9
Remote fax commands
Follow the commands below to access features when you are away from the machine. When you
call the machine and enter your Remote Access Code (3 digits followed by l), the system will
give two short beeps and you must enter a remote command.
Remote commands Operation details
95 Change the fax forwarding,
paging or fax storage settings
1 OFF
You can choose Off after you have retrieved or erased all your
messages.
2 Fax forwarding One long beep means the change is accepted. If you hear three
short beeps, you cannot change because something has not
been set up (for example, a fax forwarding or paging number
had not been registered). You can register your fax forwarding
number by entering 4. (See Changing the Fax Forwarding
number on page 68.) Once you have registered the number,
fax forwarding will work.
3 Paging
4 Fax forwarding number
6 Fax storage
96 Retrieve a fax
2 Retrieve all faxes
Enter the number of a remote fax machine to receive stored fax
message(s). (See Retrieving fax messages on page 68.)
3 Erase faxes from the memory If you hear one long beep, fax messages have been erased
from the memory.
97 Check the receiving status
1 Fax
You can check whether your machine has received any faxes.
If yes, you will hear one long beep. If no, you will hear three
short beeps.
98 Change the receive mode
1 External TAD
If you hear one long beep, your change has been accepted.
2 Fax/Tel
3 Fax Only
90 Exit Press 9, 0 to exit remote retrieval. Wait for the long beep, then
replace the handset.