For wireless network users, Recommended), For windows – Brother HL 5370DW User Manual
Page 23
23
For Wireless Network Users
Wireless Network
Windows
®
Macintosh
7
Confirm your network environment (Infrastructure Mode)
Choose a configuration method and proceed to the page indicated.
Configuration using the Brother installer application on the CD-ROM
(Recommended)
Configuration temporarily using a network cable
You need to temporarily use an Ethernet cable when you configure your Brother printer with this
method. The Ethernet cable is not a standard accessory.
If there is an Ethernet Hub or Router in the same network as the wireless access point
a
, you can temporarily connect
the Hub or Router to the printer using an Ethernet cable
b
. This is an easy way to configure the printer. You can then
remotely configure the printer from a computer on the network.
Now go to
For Windows
®
Users go to page 24
For Macintosh Users go to page 33
Configuration using the automatic wireless (one-push) method
If your wireless access point
a
supports either SecureEasySetup™, Wi-Fi Protected Setup (PBC
) or AOSS™, you can
configure the printer without knowing your wireless network settings. The access point /router and your printer can
automatically negotiate using the SecureEasySetup™, Wi-Fi Protected Setup or AOSS™ procedure.
1
Push Button Configuration
Configuration using the PIN Method of Wi-Fi Protected Setup
If your wireless access point
a
supports Wi-Fi Protected Setup, you can also configure using the PIN Method of
Wi-Fi Protected Setup. For instructions, see Chapter 7 in the Network User’s Guide on the CD-ROM.
Now go to
For Windows
®
Users go to page 29
For Macintosh Users go to page 38
11
1
2
1
1