Brother Innov-is 6000D - Manual (Page 20)

19
EN
G
LIS
H
■ 3D combination motifs
XKIT2B07.pes
How to make 3D combination motifs
1. Use the same color of thread in the bobbin and on top for the designs.
2. Embroider individual shapes. When sections are completed they are joined to make dimensional shapes. Use a
thread or narrow ribbon of a complimentary color to join them.
3. Turn off the “Jump stitch thread cutting function” before embroidering. (Refer to the Operation Manual for
directions on how to do this.)
The following are things you should be aware of when using water-soluble sheets without any fabric. When
embroidering these designs, please use three layers of water-soluble sheets.
Remember to check that you have enough upper thread and lower thread for the design. If the thread breaks during
embroidery, back up at least 10 stitches before starting again. If your embroidery machine has a speed reduction
feature, select the lowest speed. When dissolving the water-soluble sheet, cut off the unnecessary portions and wash
the embroidered piece in warm water until it no longer feels slippery. After the final rinse, dry the embroidery motif
until slightly damp, shape by hand or with a cool iron, allow to dry completely.
■ Examples of Combinations
XKIT2B08.pes × 2 XKIT2B09.pes × 4 XKIT2B10.pes × 4
A
A
E
B
D
B
C
A
C
B
B
E
B
B
A
D
B
B D