Brother DS-600 - Manual (Page 36)

Mac OS ® X Operation
18
2
INSTALLING SOFTWARE
Insert the Installation DVD that came with your DSmobile 600 scanner into your Mac ® computer and follow
the steps below.
a Make sure your Macintosh ® system software is Mac OS ® X v10.3, v10.4, v10.5, v10.6 or v10.7 and that
your application software works native and not in emulation of lower system software versions.
b
Do not connect the DSmobile 600 scanner to your Macintosh ® until after the driver installation.
c We recommend that the first installation and calibration should be done using an Administrator account.
(See SETTING ADMINISTRATOR PRIVILEGES)
d Click on the DVD icon, and then open “Macintosh” folder.
e
Double click on DSmobile 600 Driver.pkg.
f
Click on “Continue”.
g Select the disk for the installation or click “Continue”.
h Click “Install”.
i Close other application software and then click “Continue Installation”.
j
When the installation is complete, click “Logout”.
k Connect your DSmobile 600 scanner to a Macintosh ® USB port.
l Start your TWAIN-compliant application software. The Macintosh ® is supplied with “Image Capture”
software but you may use other TWAIN-compliant software. Refer to Calibrating your DSmobile 600
Scanner using “Image Capture” uu page 21 for instructions on calibrating with “Image Capture”.
(For Mac OS
® X v10.6 and v10.7, Refer to Performing Scanner Calibration uu page 33 for instructions
on calibrating with “PageManager ® 9”)
m
Select “DSmobile 600” as scanning device.
n Follow the on-screen instructions for calibration and scanning.
o Note that when using the DSmobile 600 on a Macintosh ® , the scan button on the top of the scanner does
not start scanning software automatically (available for Windows ® OS only).