Brother HL-6180DW - Manual (Page 24)

24
For Wireless Network Users
One push setup using WPS (Wi-Fi Protected Setup) or AOSS™
(Windows
® and Macintosh)
11
Configure the wireless
settings
a
Confirm your wireless access point/router has
the WPS or AOSS™ symbol as shown below.
b
Place the Brother machine within range of your
WPS or AOSS™ access point/router. The
range may differ depending on your
environment. Refer to the instructions provided
with your wireless access point/router.
If you began the wireless setup from step
5 on
page 5, go to d.
All other users, go to c.
c
On your machine, press a or b to choose
Network
and press OK.
Press a or b to choose WLAN and press OK.
d
Press a or b to choose WPS/AOSS and press
OK.
When WLAN Enable? is displayed, press a to
accept. This will start the wireless setup wizard.
Otherwise press Cancel to exit from the
wireless setup wizard.
e
When Press Key on rtr appears, press
the WPS or AOSS™ button on your wireless
access point/router. See the user’s guide for
your wireless access point/router for
instructions. And then press a.
This feature will automatically detect which
mode (WPS or AOSS™) your wireless access
point/router uses to configure your machine.
f
A connection result message appears on the
LCD and a WLAN report will automatically be
printed.
If the connection failed, check the error code on
the printed report and refer to
Troubleshooting on page 25.
To install the printer driver, continue to
step 12.
For Windows ® Users:
Now go to
page 28
For Macintosh Users:
Now go to
page 30
Note
If your wireless access point/router supports WPS
(PIN Method) and you want to configure your
machine using the PIN (Personal Identification
Number) Method, see Configuration using the
PIN Method of WPS (Wi-Fi Protected Setup) in
the Network User's Guide.
Wireless setup is now complete. A four
level indicator at the right of your
machine’s LCD will show the wireless
signal strength of your wireless access
point/router.