Brother PT-3600 - Manual (Page 103)

91
TROUBLESHOOTING
(4) The P-touch is not working correctly. ● Reset the P-touch by turning it off, then
while holding down
d and R, turning
the machine back on.
☞ All settings will be reset to their defaults
and the entire contents of the memory will
be cleared. If it necessary to keep the cur-
rent settings and stored files, back them up
to the computer using the P-touch Backup
Manager.
☞ Before installing or removing the tape cas-
sette, be sure that the P-touch has been
reset.
(5) The machine has “locked up” (i.e., noth-
ing happens when a key is pressed).
● Reset the machine by:
- (PT-3600) unplugging the AC adaptor,
and leaving it unplugged for about one
minute, then and plugging it in again
- (PT-9600 only) pressing the reset button
in the battery compartment at the bottom
of the machine
☞
The text and formats in the display and all
text files stored in the memory will be
erased.
☞ Before installing or removing the tape cas-
sette, be sure that the P-touch has been
reset.
(6) The half cut is either too deep or not deep
enough.
● Follow the procedure on pages 82 to
adjust how deep laminated tape is cut.
Problem Solution