Brother HL-4200CN - Manual (Page 40)

NOVELL NETWARE PRINTING 6 - 2
Queue Server Mode (Recommended)
In the Queue Server mode, the printer functions as the print server by retrieving and printing print jobs
from the print queues on the file server. As it fully utilizes the printer functions, the system capacity of
this mode is better than that of the remote printer mode. However, the printer uses one user license on
the file server.
Remote Printer Mode
In the remote printer mode, the print server running on the file server sends jobs to the printer. The printer
prints out the jobs retrieved from the print server. In this mode, the printer does not use up any user
license of the file server.
To install your printer in a NetWare environment, you must ensure that you log on as SUPERVISOR (for
NetWare 3.x) or ADMIN (for NetWare 4.x 5.x)
Interface
The following frame types are supported:
Ethernet II specifications
IEEE802.3 specifications
IEEE802.2 specifications
SNAP specifications
The frame types are automatically detected. However, if you wish to select a specific frame type, use the
control panel, a web browser or the BRAdmin Professional utility.
Configuring NetWare System
1
Start the BRAdmin Professional utility and select the printer icon you wish to configure. Click the
Configure Device icon.
2
Enter the password and click OK. (The default password is ‘access’.)
3
Select the Netware tab.
4
Select the Operating Mode you want to use.
For directory service:
When you select NDS Queue Server or NDS Remote Printer,
see Configuring in Directory Service (NDS) -3.
For bindery service:
When you select Bindery Queue Server or Bindery Remote Printer, see Configuring in Bindery Service
in this chapter