Brother HL 2270DW - Manual (Page 17)

Configuring your machine for a wireless network (For HL-2135W, HL-2270DW and HL-2275DW)
13
3
 You can remotely configure the machine from a computer that is also on the network using a USB cable
(A)
1
.
1 You can configure the wireless settings of the machine using a USB cable temporarily connected to a wired or wireless computer.
 (For HL-2270DW and HL-2275DW) If there is an Ethernet Hub or Router on the same network as the
WLAN access point (A), you can temporarily connect the Hub or Router to the machine using a network
cable (B). You can then remotely configure the machine from a computer on the network.
Configuration using the one-push wireless setting mode to configure your
machine for a wireless network (Infrastructure mode only)
3
If your WLAN access point/router (A) supports either Wi-Fi Protected Setup (PBC
1
) or AOSS™, you can
configure the machine without a computer.
1 Push Button Configuration
A
B
A
A