Brother HL 2270DW - Manual (Page 19)

Configuring your machine for a wireless network (For HL-2135W, HL-2270DW and HL-2275DW)
15
3
Configuring your machine for a wireless network
(for Infrastructure mode and Ad-hoc mode)
3
IMPORTANT
• If you are going to connect your Brother machine to your network, we recommend that you contact your
system administrator prior to installation. You must know your wireless network settings before you
proceed with this installation.
• If you have previously configured the wireless settings of the machine, you must reset the print server back
to its factory default settings (see Reset the network settings to the factory default on page 26.)
Using the Brother installer application on the CD-ROM to configure your
machine for a wireless network
3
For installation, see the Quick Setup Guide.
Using the one-push wireless setting mode to configure your machine for a
wireless network
3
If your WLAN access point/router supports either Wi-Fi Protected Setup (PBC
1
) or AOSS™, you can
configure the machine easily without knowing your wireless network settings. Your Brother machine has
one-push wireless setting mode. This feature automatically detects which mode your WLAN access
point/router uses for one-push configuration (Wi-Fi Protected Setup or AOSS™). By pushing a button on the
WLAN access point/router and the machine, you can setup the wireless network and security settings. See
the user’s guide supplied with your WLAN access point/router for instructions on how to access one-push
mode.
1 Push Button Configuration
Note
Routers or access points that support Wi-Fi Protected Setup or AOSS™ have the symbols shown below.