Changing the scan key settings, Before scanning, Scan key settings – Brother DCP-8110DN User Manual
Page 44: Before scanning scan key settings
Chapter 7
34
Changing the SCAN key settings
7
Before scanning
7
To use the machine as a scanner, install a scanner driver. If the machine is on a network,
configure it with a TCP/IP address.
Install the scanner drivers from the Installer CD-ROM. (See Quick Setup Guide.)
Configure the machine with a TCP/IP address if network scanning does not work.
(See Software User's Guide: Configuring Network Scanning (Windows
®
).)
SCAN key settings
7
You can change your machine’s SCAN key settings using ControlCenter4.
a
Open ControlCenter4 by clicking Start/All Programs/Brother/XXX-XXXX (where
XXX-XXXX is your model name)/ControlCenter4. The ControlCenter4 application will open.
b
Make sure the machine you want to use is selected from the Model pull-down list.
c
Click the Device Settings tab.
d
Click Device Scan Settings.