Brother HL-8050N - Manual (Page 13)

12
Setting Up Your Printer
Do NOT connect the interface cable.
Connecting the interface cable is
done when installing the driver.
1
Remove all the packing tape.
2
Open the top cover.
Do not touch any parts inside the
printer.
3
Take the toner cartridge out of the box and
rock it 7 to 8 times.
4
Place the toner cartridge on a flat surface
and pull the seal out horizontally.
5
Hold the toner cartridge by the grip and
insert it into the slot inside the printer.
6
Close the top cover securely.
1 Install the Toner Cartridge
Top cover
■ When pulling out the seal, pull it out
horizontally. The tape might break if it is
pulled out diagonally.
■ After the seal has been pulled out, do not
shake or bump the toner cartridge.
Make sure that the toner cartridge is firmly
set.
Step 1
Seal
Toner cartridge