Asante Technologies 7000 - Manual (Page 26)

LED Indicators
Page 3-2
Figure 3-2 FS7000 LEDs
Units with a Gigabit SX XP module installed have the following additional
LEDs for monitoring the status of the Gigabit port:
❑ Power
❑ Link/Data
❑ Full Duplex/Collision
Power On LED Indicators
After power is turned on, the LED indicators should respond as follows:
❑ All LED indicators blink momentarily. This represents a system reset.
❑ The Link/Data LEDs blink from slow to steady as traffic increases.
❑ The Power LED indicator lights and remains ON. If this indicator is
not lit, check to make sure that the power cord is properly connected
at both ends.
MII Power LED
The green MII Power LED indicates whether an MII 100Base-FX module is
connected to the Switch. Table 3-1 describes the possible status indications of
the MII Power LED.
Table 3-1 MII Power LED Status Indicator
State Status
On 100Base-FX module is connected
Off 100Base-FX module is not connected
Power
100/10Mbps
Full/Half
Link/Data Power
FriendlyNET 7000 Series Gigabit Switch
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
100/10Mbps
Full/Half
Link/Data
A1 A2 A3 A4 A5 A6 A7 A8 B1 B2 B3 B4 B5 B6 B7 B8
100/10 Mbps
Full/Half
Link/Data
100/10 Mbps
Full/Half
Link/Data