Canon Speedlite 320EX - Manual (Page 20)

18
FE (flash exposure) lock locks the correct flash exposure setting for any
part of the scene.
With the flash mode set to E-TTL II/E-TTL autoflash, press the camera’s
<A> button to enable FE lock. On some cameras, press the <B> or
<7> button.
1
Focus the subject.
2
Press the <A> button. ( 8 )
Aim the center of the viewfinder over
the subject and press the <A> button.
X The Speedlite fires a preflash, and
the required flash output is retained in
memory.
X “FEL” will be displayed in the
viewfinder for approx. 0.5 sec.
Each time you press the <A> button,
a preflash will be fired and a new
flash exposure reading will be locked.
3
Take the picture.
Compose the picture and press the
shutter button completely.
X The flash fires when the picture is
taken.
A FE LockN
If the subject is too far away and underexposure may result, the <D>
icon will blink in the viewfinder. Move closer to the subject and perform
FE lock again. You can also increase the ISO speed and perform FE lock
again when using a digital camera.
If the target subject is too small in the viewfinder, the FE lock might not
be very effective.
COP
Y