Canon LV 7490 - Manual (Page 11)

11
Part Names and Functions
Rear Terminal
② ③ ① ④
⑤ ⑩ ⑥ ⑧ ⑦ ⑨
⑤ S-VIDEO IN
Connect the S-VIDEO output signal from
video equipment to this jack (p.17).
⑦ AUDIO IN
Connect the audio output signal from
video equipment connected to ⑤ or ⑧ to
this jack. For a mono audio signal (a single
audio jack), connect it to the L (MONO)
jack (p.17).
⑨ COMPUTER AUDIO IN 1
Connect the audio output (stereo) from a
computer or video equipment connected
to ② to this jack (pp.16, 18).
⑧ VIDEO IN
Connect the composite video output signal
to this jack (p.17).
② COMPUTER IN 1 / COMPONENT IN
Connect output signal from a computer, RGB
scart 21-pin video output or component video
output to this terminal (pp.16,18).
④ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this
jack (pp.16-18).
This terminal outputs sound from AUDIO IN
terminal (⑦ or ⑨).
Never plug headphones into this jack.
① LAN Connection Terminal
Connect the LAN cable (refer to the user’s
manual of "Network Set-up and Operation").
⑥ CONTROL PORT
When controlling the projector with
RS-232 C, connect the control equipment
to this connector with the serial control
cable.
③ COMPUTER IN 2 / MONITOR OUT
– Connect computer output to this terminal
(p.16).
– This terminal can be used to output the
incoming analog RGB and Component signal
from COMPUTER IN 1/COMPONENT IN
terminal to the other monitor (pp.16,18).
⑩ COMPUTER AUDIO IN 2 (MIC IN)
Connect the audio output (stereo) from a
computer or video equipment connected
to ③ to this jack. Or connect the MIC to
the this jack (pp.16, 18).