Canon Wireless File Transmitter WFT-E2 II A - Manual (Page 14)

14
This section describes the process of following the connection wizard instructions. If an error is
displayed, refer to “Troubleshooting” in Chapter 8 (p.71) and check the settings.
Pressing the shutter button or other camera controls during configuration by the connection
wizard will close the connection wizard. Do not press the shutter button or other controls
until configuration is finished.
On the [5] tab, set [Auto power off] to [Off]. If auto power off is activated, the connection
wizard will be closed during the configuration process.
1 Turn the camera on.
2 Display the transmitter menu.
On the camera, press the <7> button.
On the [7] tab, select [WFT settings] and press
<0>. [WFT settings] is added to the tab after you
attach the transmitter.
3 Select [Connection wizard].
X The [Select communication method] screen is
displayed.
X The <LAN> lamp starts blinking.
Displaying the Connection Wizard
Although terminology on the [Select communication method] screen has been updated since the
WFT-E2, the functionality is the same.
Cameras updated with firmware versions enabling the use of WFT-E2 II will display the same
information for [Select communication method] and [Communication mode] whether WFT-E2
or WFT-E2 II is attached.
COP
Y