Agri-Fab Chip-N-Vac 45-0253 - Manual (Page 10)

10
FIGURE 11
20. Place a side panel on top of the cart bed flange,
inside the lip of the front panel. Fasten the side panel
to the front panel using three 1/4" x 5/8" hex bolts
and 1/4" nylock nuts. Fasten the side panel to the cart
bed flange using two 1/4" x 5/8" hex bolts, 1/4" flat
washers and 1/4" nylock nuts.
Tighten. See figure 11.
Repeat on other side.
FIGURE 12
23. Assemble a door latch at each end of the cross brace
using a 5/16" x 3/4" hex bolt, a nylon washer and a
5/16" nylock nut. Place the nylon washer between the
door latch and cross brace.
Tighten
so that latch is
snug but will still rotate. See figure 13.
FIGURE 13
24. Install the poly hard top using fourteen 1/4" x 3/4"
hex bolts and 1/4" flat washers on the outside and
fourteen 1/4" flat washers and 1/4" nylock nuts on the
inside.
Tighten. See figure 14.
FIGURE 14
1/4" x 5/8"
HEX BOLT
1/4" FLAT
WASHER
1/4" NYLOCK NUT
1/4" NYLOCK NUT
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK NUT
1/4" x 5/8"
HEX BOLT
CROSS
BRACE
1/4" NYLOCK NUT
1/4" x 1"
HEX BOLT
1/4" NYLOCK NUT
5/16" x 3/4"
HEX BOLT
CROSS
BRACE
DOOR
LATCH
NYLON
WASHER
5/16" NYLOCK NUT
1/4" x 3/4"
HEX BOLT
1/4" FLAT
WASHER
1/4" NYLOCK NUT POLY HARD TOP
1/4" FLAT
WASHER
21. Screw a 1/4" nylock nut onto a 1/4" x 1" hex bolt until
it is about 1/4" from the bolt head. Insert the bolt into
the hole shown in the side of the cart in figure 12.
Fasten the bolt to the cart using a 1/4" nylock nut.
Tighten
so that the nut is one or two threads past the
end of the bolt. Repeat on the other side.
22. Assemble the cross brace to the top rear holes in the
side panels using four 1/4" x 5/8" hex bolts and 1/4"
nylock nuts. See figure 12.